I made up this model a month or two ago. It's basically the length of the sensors I purchased plus an additional 0.8mm to set the proper gap. I've printed it out, but not yet tried as my bracket in my car was broken, and I'm waiting for the replacement to show up, but there's not much to it, and I confirmed the length is about 0.8mm longer them my new sensor. Your printer might vary, so I'd double check after printing. Hope someone finds it helpful.
https://makerworld.com/en/models/239035 ... Id-2618559
Speed / Reference Sensor 0.8mm Gap Model
-
Tom
- Site Admin
- Posts: 8925
- Joined: Fri Jun 25, 2021 2:04 pm
- Location: Silicon Valley, CA
- Has thanked: 932 times
- Been thanked: 3993 times
- Contact:
Awesome --I held off making one in support of a Carpokean who sold them, but he's since stopped and encouraged others to jump in, so your timing is perfect. Please post the model here on Carpokes! We are working hard for Carpokes to be a central repository of Porsche-related STL's rather than seeing them spread out over the large general purpose sites like makerworld, thingiverse, etc.eccs19 wrote: Tue Apr 14, 2026 4:23 am I made up this model a month or two ago. It's basically the length of the sensors I purchased plus an additional 0.8mm to set the proper gap. I've printed it out, but not yet tried as my bracket in my car was broken, and I'm waiting for the replacement to show up, but there's not much to it, and I confirmed the length is about 0.8mm longer them my new sensor. Your printer might vary, so I'd double check after printing. Hope someone finds it helpful.
https://makerworld.com/en/models/239035 ... Id-2618559
(You can upload by clicking Add Pictures/Files below.)