Paragon Adjustable Ride Height Spanner

[yugami]

I bought the Paragon "Coil Over Kit - Front" to go with my Koni sport inserts. But absentmindedly did not make sure I had a spanner to adjust the ride height after install.

Not wanting to wait, I pulled up the DIN standard for a pin Wrench and made one. This is not 100% DIN compliant because the DIN spec would be good for a range and I made this with a single radius so its specific to the mount.

2 versions, one with a shorter handle to work better in the wheel well, but the long handle works fine and gets roughly 180 degrees at minimum.

74a0c436-d129-4d5e-a81f-4854a1c7d6bb.jpg

Very low impact in terms of force, but still I printed it with a large number of walls and top/bottom + very high infill %. Worked a treat, and since I'll probably never touch the ride height again now that its where I want it I'm glad I didn't spring for a real tool.