Spacers for Manholes
Posted: Sat Jun 08, 2024 6:54 am
After going back to a set of manholes that I picked up a while ago, I was informed that I should put on some spacers similar to the original parts. I used H&R 21mm parts. Here is that story, in pictures.
I took the car for a drive and, so far, so good.
Cheers
- The included nuts
- 20240607_090331.jpg (3.73 MiB) Viewed 4613 times
- Conical seats for the included nuts
- 20240607_090344.jpg (3.73 MiB) Viewed 4613 times
- There was a lot of tire back there
- 20240607_081855.jpg (3.26 MiB) Viewed 4613 times
- On these wheels, there is plenty of space to handle the protrusion of the original wheel studs
- 20240607_082719.jpg (3.47 MiB) Viewed 4613 times
- Rears without spacers
- 20240527_170933.jpg (3.81 MiB) Viewed 4613 times
- Rears with spacers
- 20240527_170605.jpg (3.29 MiB) Viewed 4613 times
- Starting place, OZ Alleggeritas from a 99X
- 20240527_180114.jpg (3.18 MiB) Viewed 4613 times
- The original studs protrude, but no worries
- 20240607_083239.jpg (3.35 MiB) Viewed 4613 times
Cheers