Seatbelt Bolthead Cap
Posted: Fri May 10, 2024 8:30 am
I only have 1, but luckily I have the one.
So this is as close to OEM as I could get it and keep it nice and printable. The hex is a tiny but undersized so it snaps on nice and solid.
I printed in ABS with a 97,5% shrinkage modifier (things are scaled by 2.5 percent to compensate for the plastic becoming undersized)
Polishes up easily with 360 and 600 grit. Then SEMS Trim Black.
So this is as close to OEM as I could get it and keep it nice and printable. The hex is a tiny but undersized so it snaps on nice and solid.
I printed in ABS with a 97,5% shrinkage modifier (things are scaled by 2.5 percent to compensate for the plastic becoming undersized)
Polishes up easily with 360 and 600 grit. Then SEMS Trim Black.