Center speaker gauge housing
Posted: Thu Apr 11, 2024 5:27 am
Gauge housing that fits two 52mm gauges in place of the center speaker.
Fits in original speaker cover pin holes, slides right in, no extra mods to dash is needed.
Link to stl on Cults3d: https://cults3d.com/en/3d-model/gadget/ ... ge-housing
Don't print in PLA!
Use ASA or ABS.
Fits in original speaker cover pin holes, slides right in, no extra mods to dash is needed.
Link to stl on Cults3d: https://cults3d.com/en/3d-model/gadget/ ... ge-housing
Don't print in PLA!
Use ASA or ABS.