Carpokes Porsche Forum

Here are STL files for a MagSafe charging port you can install in the late 944, in the ashtray location. See video below for installation details. This is designed around a standard Apple-branded MagSafe charger. Best to print in ABS, ASA or other heat resistant plastic for hot car interiors. I print it with supports for the little notch area, but you could probably get away without support.

Here is the standard one-piece part:
And here are files for the 2-piece version, as explained in video:



Finally, here is another version of the base plate with room around the edges to allow it to be covered in leather/vinyl, along with a cut-out for the common 703PR-102 knock counter. See picture below. Note the separate bezel file for the knock counter. See here for info on the knock counter itself.

This is some really cool work. I might try it with my Porsche 944 N/A from 85. I currently put a little 3D printed tray instead of the original piece but always struggling to have a decent way to charge my phone…

I vote for CE to tie a bow around this by covering in leather to match your center console.

Larry C wrote: Tue May 30, 2023 7:00 am I vote for CE to tie a bow around this by covering in leather to match your center console.

As of this weekend, it is! See that last pic above. I covered it myself, but with authentic Crazy Eddie leather -- same leather as the rest of the interior except 'skived' to a .8mm thickness.

I see it - perfect.