Carpokes Porsche Forum

Hi there, Who prints the plastic 3D rear hatch pin sleeves for the rear deck lid on the 944 series? This is supposed to fix the common "squeaky" hatch problem with the 944 series?.... Is it the same guy that makes the heater vent clips for the 944?

Are these the things you're looking for...
https://only944.com/partscatalog/only/hatchpinseats/

We carry these they are exact replicas of what was there originally.

https://944online.com/rear-hatch-receiv ... r-kit.html

Thanks all ready ordered them!

These dense plastic or nylon pin sleeves completely eliminated the constant squeak, squeak, squeak that my '86 Porsche 951 had for oh, the last 37k miles. Now I can drive my car over rough or smooth roads, take super sharp curves, accelerate and brake hard - the squeaks are 100% GONE!
A related note: My car has the early Billy Boat full polished SS cat-back 3" pipe exhaust (circa 1996-1998?) with the deep tone muffler (not the louder race track version) and the Large oval tailpipe. Without the incessant rear hatch squeaking, I can now fully enjoy the smooth, rich sound of the 951 engine exhaust note unleashed. Sweet, sweet music indeed!