Page 2 of 2
Re: Rear seat post
Posted: Fri May 10, 2024 3:29 pm
by pestilence68
yugami wrote: Fri May 10, 2024 3:23 pm
pestilence68 wrote: Fri May 10, 2024 12:44 pm
I have not. I am still interested in getting them printed.
Do you want one of each or two of a specific one?
I printed 2 of the flange one and trimmed one of the flanges straight
Nice! How did they fit?
Re: Rear seat post
Posted: Fri May 10, 2024 4:02 pm
by yugami
pestilence68 wrote: Fri May 10, 2024 3:29 pm
Nice! How did they fit?
PXL_20240510_225822722.MP.jpg
Look pretty good. The filament needs to be dried to get a better surface finish so I'm going to run it through the drier overnight and reprint. I'll print a set for you as well.
Re: Rear seat post
Posted: Fri May 10, 2024 5:14 pm
by pestilence68
Sweet! Thanks!
Re: Rear seat post
Posted: Sat May 11, 2024 3:41 pm
by yugami
Sent you a DM (just in case you didn't see the notification)