For those that shaved the bumper pads and have a big gap between the turn lights and bumper. Disclaimer this is my first real foray into 3d file design, happy to get feed back and tips on improvement of the design.
I have yet to fit my “prototype” on the car. But here is a pic of it printed in PLA (on the car i will use ABS/ASA) and may sand and color match to the car.
944 NA bumper pad delete
-
Synapse120
- Posts: 25
- Joined: Sat Jan 15, 2022 3:16 am
- Has thanked: 2 times
- Been thanked: 8 times
You need to be registered and logged in to download files. Registration is free and easy!
-
Synapse120
- Posts: 25
- Joined: Sat Jan 15, 2022 3:16 am
- Has thanked: 2 times
- Been thanked: 8 times
Here is the gap I’m referring to, and the part held up in the spot. Already see areas for improvement
You need to be registered and logged in to download files. Registration is free and easy!
-
Synapse120
- Posts: 25
- Joined: Sat Jan 15, 2022 3:16 am
- Has thanked: 2 times
- Been thanked: 8 times
Redesigned and fit to the car (only one bolt screwed down)
You need to be registered and logged in to download files. Registration is free and easy!
-
Synapse120
- Posts: 25
- Joined: Sat Jan 15, 2022 3:16 am
- Has thanked: 2 times
- Been thanked: 8 times
V2 printed in ABS and mounted to the car. I also realized i didn’t post the STL for V2
You need to be registered and logged in to download files. Registration is free and easy!
-
Dirk Matthee
- Posts: 1
- Joined: Fri Jul 01, 2022 11:22 pm
- Been thanked: 1 time
Did anyone attempt the Euro spotlight surrounds yet?
-
Tom
- Site Admin
- Posts: 8951
- Joined: Fri Jun 25, 2021 2:04 pm
- Location: Silicon Valley, CA
- Has thanked: 936 times
- Been thanked: 4016 times
- Contact:
It's attached in post 4 of this thread. Until you have one post yourself on Carpokes, you can't download files, but by virtue of asking that question, you can now see the file and download it.
