951 Resurrection - after 7 years of storage

[Meine44]

Hardline PS clamp is 10 x 15 clamp pn 99951111602
I think any 15mm diameter clamp would work, but hope that helps. I order nuts, bolts and clamps from Belmetric.com , they have p clamps there too. I think you need an m6 mounting hole.

Yes, that is helpful, thank you! I will add this to the list of items to source from the local hardware store.

Sometimes I get stuck searching the PET parts catalog and forget that I have the ability to remove small parts like this and bring them into a brick-and-mortar store for comparing

[Tom]

Also, I would appreciate any help identifying two small pieces that I need to replace:

-The clip that holds the rear interior trim piece to the body of the car. Two are broken and one is missing. This clip holds the interior trim / leather side panel to the inside of the trunk.

-There is a hard-line clamp near the oil pressure sender that has disintegrated - the rubber is thrashed.

You can get those cushion clamps at a local hardware store, or amazon, though the ones Porsche sells are higher quality by a country mile (thicker rubber, thicker metal)... That panel clips are available, but you may need to re-secure them in the panels (JB Weld, etc.)... I 'think' your picture shows this style...