I got my block back from the shop and noticed the alignment dowels are missing at the back of the block. I guessed/ordered a 911 part number, but it was too big.
Does anyone know the straight pin part number? It is not on PET.
Thanks.
Bellhousing dowel
- Tom
- Site Admin
- Posts: 5209
- Joined: Fri Jun 25, 2021 2:04 pm
- Location: Silicon Valley, CA
- Has thanked: 485 times
- Been thanked: 2276 times
- Contact:
I may have one -- will look tomorrow...
If 16mm OD is too big, there might be something else going on. The bolts are 12mm so there's not much room for a smaller dowel.
The dowels should press into the block. What's the ID of the dowel hole in the block?
The dowels should press into the block. What's the ID of the dowel hole in the block?
- Tom
- Site Admin
- Posts: 5209
- Joined: Fri Jun 25, 2021 2:04 pm
- Location: Silicon Valley, CA
- Has thanked: 485 times
- Been thanked: 2276 times
- Contact:
There are 2 dowel pins in the back of my 86 block. and they are both a hair under 10mm in diameter per my calipers (like 9.95). There is also 1 roll pin that measures about 10.8mm installed.